Amplifier Research 30S1G6 Microwave Amplifier :  The Amplifier Research Model 30S1G6 is a solid-state, Class A design, self-contained, air-cooled, broadband amplifier designed for applications where instantaneous bandwidth and high gain are required. Housed in a stylish contemporary cabinet, the unit is designed for benchtop use, but can be removed from the cabinet for immediate equipment rack mounting. The 30S1G6, when used with a sweep generator, will provide a minimum of 30 watts of RF power. Included is a front panel gain control which permits the operator to conveniently set the desired output level. The AR 30S1G6 is protected from RF input overdrive by an RF input leveling circuit which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0 dBm. The RF amplifier stages are protected from over-temperature by removing the DC voltage to them if an over temperature condition occurs due to cooling blockage or fan failure. There is a digital display on the front panel to indicate the operate status and fault conditions when an over-temperature or power supply fault has occurred. The unit can be returned to operate when the condition has been cleared. The Amplifier Research 30S1G6 includes digital control for both local and remote control of the amplifier. All amplifier control functions and status indications are available remotely in GPIB/IEEE-488 format, RS-232 hardwire and fiber optic, USB, and Ethernet. The bus interface connector is located on the back panel and positive control of local or remote operation is assured by a Local/Remote switch on the front panel of the amplifier. The export classification for this equipment is EAR99. Functions and Specifications of the Amplifier Research 30S1G6 Microwave Amplifier Includes: RATED POWER OUTPUT: 30 watts minimum (1.0-6GHz) POWER OUTPUT @ 3dB COMPRESSION:Nominal: 40 wattsMinimum: 28 watts POWER OUTPUT @ 1dB COMPRESSION:Nominal: 30 wattsMinimum: 22 watts SMALL SIGNAL GAIN FLATNESS: ±1.5 dB typical ±2.0 dB maximum FREQUENCY RESPONSE: 1.0–6GHz instantaneously INPUT FOR RATED OUTPUT: 1.0 milliwatt maximum GAIN (at maximum setting): 44 dB minimum GAIN ADJUSTMENT (Continuous Range): 10 dB minimum(4096 steps remote) INPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum OUTPUT IMPEDANCE: 50 ohms, nominal MISMATCH TOLERANCE: 100% of rated power without foldback. Willoperate oscillation with any magnitude and phase of sourceand load impedance. MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulsemodulation appearing on the input signal HARMONIC DISTORTION: Minus 20 dBc maximum at 25 watts SPURIOUS : Minus 73 dBc typical THIRD ORDER INTERCEPT POINT: 50 dBm typical NOISE FIGURE: 10 dB typical PRIMARY POWER (selected automatically): 90-132, 180-264 VAC 50/60 Hz, single phase 300 watts maximum SAFETY INTERLOCK: 15 Pin Subminiature D COOLING: Forced air (self contained fans) EXPORT CLASSIFICATION: EAR99     

• Amplifier Research 30S1G6 - Datasheet (0 B)