Aplifier Research 25S1G6AB Microwave Amplifier : The Model 25S1G6AB is a solid-state, Class AB design, self-contained, air-cooled, broadband amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Housed in a stylish contemporary cabinet, the unit is designed for benchtop use, but can be removed from the cabinet for immediate equipment rack mounting.  The 25S1G6AB, when used with a sweep generator, will provide 25 watts typical of RF power. Included is a front panel gain control which permits the operator to conveniently set the desired output level. The 25S1G6AB is protected from RF input overdrive by an RF input leveling circuit which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0 dBm. The RF amplifier stages are protected from over-temperature by removing the DC voltage to them if an over-temperature condition occurs due to cooling blockage or fan failure. There is a digital display on the front panel to indicate the operate status and fault conditions if an over-temperature or power supply fault has occurred. The unit can be returned to operate when the condition has been cleared. All amplifier control functions and status indications are available remotely in GPIB/IEEE-488 format, RS-232 hardwire and fiber optic, USB, and Ethernet. The bus interface connector is located on the back panel and positive control of local or remote operation is assured by a Local/Remote switch on the front panel of the amplifier.  The Model 25S1G6AB can be used as a test instrument covering multiple frequency bands and is suitable for a variety of communication technologies such as CDMA, W-CDMA, TDMA, GSM etc. It is also suitable for EMC Test applications where undistorted modulation envelopes are desired. Functions and Specifications of the Ampifier Research 25S1G6AB Microwave Amplifier Includes: RATED POWER OUTPUT: 25 watts typical POWER OUTPUT @ 3dB COMPRESSSION:Nominal: 25 wattsMinimum: 20 watts POWER OUTPUT @ 1dB COMPRESSION:Nominal: 18 wattsMinimum: 14 watts SMALL SIGNAL GAIN FLATNESS: ±1.0 dB typical ±2.0 dB maximum FREQUENCY RESPONSE: 1.0–6 GHz instantaneously GAIN (at maximum setting): 44 dB minimum GAIN ADJUSTMENT (Continuous Range): 15 dB typical(4096 steps remote) signal THIRD ORDER INTERCEPT: 48 dBm typical NOISE FIGURE: 8.5 dB typical HARMONIC DISTORTION: Minus 20 dBc typical at 20W SPURIOUS: Minus 73 dBc typical PHASE LINEARITY: ±1.0 deg/100 MHz, typical PRIMARY POWER (Selected Automatically): 90-132, 180-264VAC 50-400 Hz, single phase SAFETY INTERLOCK: 15 pin Subminiature D COOLING: Forced air (self contained fans) EXPORT CLASSIFICATION: EAR99     

• Amplifier Research 25S1G6AB - Datasheet (132 KB)