VoLTE Lab is a complete test suite for Voice-over-LTE, that includes the LTE LabKit, the Yate MiniCore and two iPhone 6s. It is fully configured and intended for use as a VoLTE test bed and learning environment.
With VoLTE Lab you can have a deep view into the internals of VoLTE technology, with Wireshark.
You can run Wireshark on the LTE Phy radio interface.
You can run Wireshark on S1-MME and S1-U interfaces and also on the S6a interface.

Components
• iPhone 6s: UEs with a very good VoLTE implementation
• LTE LabKit: a highly configurable test eNodeB/BTS with three GSM and one eNB modes
• Yate MiniCore: a software-defined compact core network for LTE/IMS and GSM/GPRS, intended for MNOs and MVNOs

Features
• Wireshark enabled
• Fully configured, fully functional VoLTE test suite
• Built on general purpose hardware
• Running Yate/YateBTS/YateENB software on Linux
• Three management interfaces (SSH, HTTP-local and remote)
• Easy to order, worldwide delivery
• Easy licensing system

The LTE LabKit LTE specifications

• Radio interface
LTE Release 12 FDD, LTE Release 12 TDD
• Available bands
filters and antennas provided for bands 5 and 8 can operate any FDD band up to 3.8 GHz
• Operating bandwidth
1.4, 2, 5, 10, 15, 20 MHz
• MAC specs
localized or distributed VRBs, proportional fairness scheduling
• Maximum connected UEs
no fixed limit
• Antenna configuration
1×1 (SISO)
• Network interface
IPv4; IPv6
• Network protocols
IP
• Output power
up to 70mW (18 dBm)

• VoLTE Lab - (439 KB)

Accessory VoLTE Lab